Unpack and Place the System
the PLC Purification System, GX-241 Liquid handler, and Verity® 4020 Single Syringe Pump
are shipped separately. follow the instructions provided in the Unpacking sections of the
PLC Purification Systems User's Guide, GX-241 Liquid Handler User's Guide, and VERITY 4X20
Syringe Pump User's Guide to unpack the modules.
Plumb the Instruments
make plumbing connections for each module (except transfer
tubing) before making system plumbing connections. refer to
Plumbing Connections on page 96 and follow all instructions detailed in Installation on page 95.
1. make all plumbing connections (except for transfer tubing) as described in the
'Plumbing Connections' sections of the VERITY 4X20 Syringe Pump User's Guide and
GX-241 Liquid Handler User's Guide.
2. make all plumbing connections described in the 'installation' chapter of this user's guide.
Connect the Transfer Tubing
Connect the transfer tubing as described in Transfer Tubing Connection on page 98.
Make the Communication and Power Connections
1. make the communication and power connections as described in the 'Power Connection'
sections of the VERITY 4X20 Syringe Pump User's Guide and GX-241 Liquid Handler User's
Guide.
2. make the power connections as described in the 'installation' chapter of this user's guide.
3. make the communication and power connections as described in
Rear Panel Connections on page 98.
Install the Racks
install appropriate racks on the GX-241 Liquid handler. refer to the 'rack installation' section
of the GX-241 Liquid Handler User's Guide.
Control Software
Control of the PLC Purification System with the GX-241 Liquid handler as autosampler with
Verity® 4020 Single Syringe Pump is via Gilson Glider Prep (GGP) Software software
accessed via the touchscreen of the PLC Purification System.
94
PLC with autoSamPLer ConfiGuration
|
PLC PurifiCation SyStemS