Start Up - Gilson PLC 2050 User Manual

Start Up

to start the PLC Purification System:
1. turn on power to the instrument, using the switch on the side panel (refer to
External Connections on page 33).
● the power indicator light below the touchscreen on the front panel illuminates.
● the automatic valve(s) status LeDs on the front panel illuminates according to the
position of the valve(s).
● the system initializes as the fraction collector arm goes to home position.
● the PC starts as the green 'Power indicator' light on the screen frame illuminates, and
the red 'Hard Drive activity' light flashes to indicate that the storage device is being
used.
● the screen switches on and displays the microsoft® Windows® logo. after one minute,
the Windows desktop appears.
2. Wait for Gilson Glider Prep Software (GGP)
to load.
● the software user interface opens and
communication is established with
devices.
● the automatic valve(s) switch to suitable
positions.
● the uV-ViS detector lamp turns on, and
the two rear fans of the detector start
spinning.
● once the software is loaded, several
graphics will appear, displaying in
real time the status of the instrument
and related components. refer to the
Gilson Glider Prep Software (GGP)
User's Guide for more information.
NOTICE
52 |
oPeration PLC 2050/2250/2500 PurifiCation SyStemS
Do not use sharp tools to touch the screen. Use the stylus or your fingers.
Figure 48
GGP Control Screen