Technical Specifications - Gilson PLC 2050 User Manual

Technical Specifications

Please be aware of the following before operating the instrument.
Changes or modifications to the instrument not expressly approved by Gilson could void
NOTICE
the factory-authorized warranty.
this instrument complies with part 15 of the federal Communications Commission (fCC)
rules. operation is subject to the following two conditions: (1) this instrument may not cause
harmful interference, and (2) this instrument must accept any interference received, including
interference that may cause undesired operation.
Shielded cables must be used with the instrument to ensure compliance with the fCC Class a
limits.
SPeCifiCation
Collection Options
Column Holder
Contact Control
Control
PLC 2050/2250/2500 Purification Systems
Definition
Several rack options available. Refer to Fraction Collector on page 84 in the
Replacement Parts and Accessories appendix.
Rack overlays for easy tube identification (optional). Refer to
Install the Rack Overlays on page 48.
Funnel rack with 16 outlets for large and variable collection volume in external high-
capacity containers (optional). Refer to Install the Funnel Rack on page 49.
Fraction collector cover kit (optional).
Install the Fraction Collector Cover Kit on page 48.
Built-in column clamp (standard). 40 mm maximum (OD) for columns. Refer to
Column Setup on page 41.
Additional standalone holder for flash columns. 400 mm maximum height. 115 mm
maximum diameter.
Analog signal input: Two contacts +/- (-1 V �� ; and +1V �� , use of
10-bit A/D converter)
Two inputs (contact closure, CMOS open drain): Start In and Stop In
(5 V �� maximum)
Two outputs (static relay contacts): Start Out and Stop Out (5 V �� maximum)
Via touchscreen PC with GGP software. Refer to the
Gilson Glider Prep (GGP) Software User's Guide.
PLC 2050/2250/2500 PurifiCation SyStemS
CONTINUED ON PAGE 22
| uSer'S GuiDe
21