Install The Stylus; Make The Power Connection - Gilson PLC 2050 User Manual

Install the Stylus

use the stylus to control the integrated software on
the touchscreen PC. a fixed holder is provided for the
stylus and its extendable cord. the stylus holder is
installed with the supplied screw on the right side of the
PLC Purification System through the threaded hole.

Make the Power Connection

the PLC Purification System is supplied with the appropriate fuses and is ready to operate
at the line voltage of the destination country. a voltage selector located near the power
receptacle allows users to adjust the input voltage of the system. Check that the position of
the voltage selector corresponds to the voltage of the mains.
to make the power connection, plug in the aC power cord into the power receptacle located
on the right side of the instrument. then make the connection between the system and the
aC power source.
● 110-120 / 220-240 V~, 50/60 Hz, 450 W (maximum)
● General fuses: t 6.3a H 250 V~ (qty. 2)
NOTE
44
inStaLLation | PLC 2050/2250/2500 PurifiCation SyStemS
fuse Drawer
Power
Switch
Figure 37
Power Switch and Voltage Selector
| indicates that the electrical power is switched on; O indicates that the electrical power is
switched off.
Set
Screw
Figure 36
Stylus and Holder
Power receptacle
Voltage
Selector
Stylus