Toshiba B-EP2DL Series System Mode Manual page 10

1. INTRODUCTION
(8) LCD message and LED indication
LCD Message
No.
ON LINE
1
ON LINE
ON LINE
2 COVER OPEN
3 PAUSE ****
4 COMMS ERROR
5 PAPER JAM ****
6 NO PAPER ****
7 NO PAPER
8 COVER OPEN ****
9 HEAD ERROR
10 EXCESS HEAD TEMP
11 SAVING ####&&&&
12 FORMAT ERROR
13 FLASH WRITE ERR.
14 FLASH MEM FULL
15 EEPROM ERROR
16 LOW BATTERY
17 AMBIENT TEMP ERR
18 BATT. TEMP ERROR
19 HIGH VOLT. ERROR
LED Indication
STATUS
Online mode
Online mode (communicating)
Strip wait
The cover was opened in online state.
Pause state
A parity, overrun, or framing error has
∆
occurred during a communication by RS-
232C.
A paper jam has occurred during paper
∆
feed.
The media has run out, or the media is not
∆
loaded properly.
The label has run out after issuing the label
∆
successfully.
A feed or printing was attempted with the
∆
Front Cover opened.
(except when the [PAUSE] key is pressed)
∆
The print head has a problem.
The print head is overheated.
∆
(71°C or more).
In writable character or PC command save
mode
An error has occurred in formatting the
∆
flash ROM.
An error has occurred in writing to the
∆
flash ROM.
Saving failed because of an insufficient
∆
capacity of the flash ROM.
Data cannot be read from/written to a
∆
backup EEPROM properly.
The battery voltage
□
7.2V or less
14.0V or less
An ambient temperature is below -20°C or over
∆
60°C.
The battery is in a dangerous condition.
∆
Care must be taken not to get burned.
∆
The battery is in a dangerous condition.
Printer Status
(B-EP2D model)
(B-EP4D model)
1- 6
EO13-33005
1.2 Operation Panel
Acceptance of
Restoration
Status Request
by PAUSE
Reset Command
key Yes/No
Yes/No
----- Yes
----- Yes
----- Yes
----- Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
----- Yes
No Yes
No Yes
No Yes
----- -----
No Yes
Yes Yes
No Yes
No Yes