Invacare Scorpius Series Service Manual page 47

Scorpius
4. Turn off the main power switch.
5. Press the folding/ unfolding button to check if the setting has been successful. Repeat the setting if the
scooter does not fold.
❖ Step 2. In setting state, a long press of 5 seconds on either the folding or unfolding button will erase all
remote control settings. After an erase the board indicator light will turn off.
❖ If this does not work, go to Remote Controller Internal Frequency Pairing Setting on next page.
Remote Controller Internal Frequency Pairing Setting:
Refer to the SERVICE-12-2 Remote Control Board Repair steps, then:
1. Check all the connectors on the rear lower shroud with the DR controller (only connectors without locking).
❖ Refer to the connector instructions in SERVICE-12 Rear Lower Shroud Repair for details.
2. Turn on the power to the remote control board and press the setting button (long-press for 3 seconds).
3. The remote control board blue light will come on and the remote control is ready for pairing.
4. Press the "unfolding button". When the indicator stops flashing, setting is complete.
❖ When reinstalling, carry out these steps in the exact reverse sequence.
❖ If function has not been restored, refer to Remote Control Board Replacement on the next page.
1654773~A
Service Manual
47