Service-13-3 Sliding Track Repair - Invacare Scorpius Series Service Manual

Scorpius
The right folding unit locking pin (shorter steel cable) passes inside the sliding base.
• With the scooter upright on an even surface confirm that it operates properly and does not
jerk or skip.
• If the folding unit steel cable has been damaged, please replace it with a new one.
• Make sure to secure the folding unit cable to the frame with a new cable tie to ensure it is
safe and secure.

2.13.3 SERVICE-13-3 Sliding Track Repair

Please carry out the SERVICE-11 Rear Top Shroud Repair and SERVICE-12 Rear Lower Shroud Repair
steps, and then:
1. Use a wrench (#13) to hold the nut and a Allen key (#5) to unfasten the Allen socket screw (1 pc) holding
the inner side of the sliding track.
2. Use the Allen key (#5) to unfasten the other screw (1 pc) at the front of the sliding track.
3. Push the left sliding track out from the back.
4. Pull it out from the front.
5. Take the left sliding track completely out.
❖ When replacing parts or re-installing, carry out these steps in the exact reverse sequence but also follow
the Re-Installation Instructions below.
❖ To remove the right-hand sliding track follow the same procedure.
• If the sliding track does not come out easily (Steps 3 and 4), shake the frame or press the
folding/ unfolding button several times to fold and unfold. This will push the sliding track out.
Be careful to keep your fingers out of the way when doing this to avoid an accident.
1654773~A
Service Manual
54