Service-12-1 Micro Switch Repair; Service-12-2 Remote Control Board Repair - Invacare Scorpius Series Service Manual

Scorpius

2.12.1 SERVICE-12-1 Micro Switch Repair

Please carry out the SERVICE-12 Rear Lower Shroud Repair steps first, then:
1. Find the micro switch which is located on the inside of the rear lower shroud.
2. Remove the two screws (8 mm, 2 pcs) on the shroud.
3. Take micro switch out.
❖ When reinstalling, please carry out these steps in the exact reverse sequence.
• When sorting out the wires make sure that the solenoid valve connector is not attached or
secured to the rear lower shroud hook. It may interfere with folding of the scooter, or even rip
and damage the solenoid valve connector. Pay special attention to this stage of the
operation.

2.12.2 SERVICE-12-2 Remote Control Board Repair

Please carry out the SERVICE-12-1 Micro Switch Repair steps for removal, then:
1. Locate the waterproof shroud of the remote control board inside the rear lower shroud.
2. Remove the four screws on the shroud.
3. Take the shroud off to expose the remote control board.
❖ When reinstalling, please carry out these steps in the exact reverse sequence.
❖ For relevant operations of the remote control board, please refer to the following Remote Control External
Frequency Pairing Setting.
Remote Control External Frequency Pairing Setting:
Unfold the scooter and equip with battery pack.
1. Turn on the main power switch and unlock the scooter.
2. Long-press the folding and unfolding buttons at the same time for 2 seconds. The board indicator (orange
light) comes on to indicate it is ready for setup.
3. Press either the folding or unfolding button once of the remote control and the light indicator will flash.
When the indicator stops flashing, setting is complete. A maximum of four remote controls can be set up
on the same unit of scooter.
1654773~A
Service Manual
46