Steps
1. Place the card-reader board in the slot on the palm-rest assembly.
2. Align the screw holes on the card-reader board with the screws holes on the palm-rest assembly.
3. Replace the three screws (M2.5x2.5) that secure the card-reader board to the palm-rest assembly.
4. Route the card-reader board cable through the routing guides on the computer base.
5. Connect the card-reader board cable to the system board.
Next steps
1. Install the
computer
base.
2. Install the
rear-I/O
cover.
3. Install the
solid-state drive in M.2 slot
4. Install the
wireless
card.
5. Install the battery.
6. Install the
base
cover.
7. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
solid-state drive from M.2 slot
5. Remove the
card-reader
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
44
two.
After working inside your
Before working inside your
two.
board.
computer.
computer.