Dell Alienware Area-51m R2 Service Manual page 57

Steps
1. Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
2. Replace the four screws (M2.5x2.5) that secure the display assembly to the palm-rest assembly.
3. Turn the computer over.
4. Replace the two screws (M2.5x8) that secure the computer base to the display assembly.
5. Adhere the Tobii cable to the computer base.
6. Route the antennas cable through the routing guides on the computer base.
7. Connect the Tobii cable to the system board.
8. Adhere the display cable and the camera cable to the computer base.
9. Connect the camera cable to the system board.
10. Connect the display cable to the system board.
11. Align the screw hole on the display-cable bracket with the screw hole on the system board.
12. Replace the screw (M2x3) that secures the display-cable bracket to the system board.
Next steps
1. Install the rear-I/O cover.
2. Install the wireless card.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
57