Installing The Left Power-Adapter Port - Dell Alienware Area-51m R2 Service Manual

4. Remove the wireless card.
5. Remove the solid-state drive from M.2 slot
6. Follow the procedure from step 1 to step 4 in
7. Remove the solid-state drive from M.2 slot
8. Remove the solid-state drive from M.2 slot
9. Remove the solid-state drive interposer
10. Remove the rear-I/O
11. Remove the computer
12. Remove the heat-sink
About this task
The following image indicates the location of the left power-adapter port and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3) that secures the power-adapter port bracket to the palm-rest assembly.
2. Slide the power-adapter port bracket off the palm-rest assembly.
3. Disconnect the left power-adapter port cable from the system board.

Installing the left power-adapter port

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the left power-adapter port and provides a visual representation of the installation
procedure.
64
one.
Removing the hard
three, if applicable.
four, if applicable.
board, if applicable.
cover.
base.
assembly.
drive, if applicable.