Installing the keyboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the keyboard and provides a visual representation of the installation procedure.
Steps
1. Place the keyboard in the slots on the palm-rest assembly.
2. Replace the 57 screws (M1.2x2.5) that secure the keyboard bracket to the palm-rest assembly.
3. Connect the keyboard cable to the audio daughter-board and close the latch to secure the cable.
4. Connect the keyboard backlight cable to the audio daughter-board and close the latch to secure the cable.
Next steps
1. Install the
system
board.
2. Install the
left power-adapter
3. Install the
heat-sink
assembly.
4. Install the
computer
base.
port.
75