Card-Reader Board; Removing The Card-Reader Board - Dell Alienware Area-51m R2 Service Manual

About this task
NOTE: If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
Steps
1. Using the alignment posts and rubber grommets, place the left speaker in the slot on the palm-rest assembly.
2. Holding the tab on the left speaker, rotate the left speaker into place in an anti-clockwise direction and secure it using the
alignment posts.
3. Route the speaker cable through the routing guides on the palm-rest assembly and the touchpad bracket.
4. Using the alignment posts and rubber grommets, place the right speaker in the slot on the palm-rest assembly.
5. Holding the tab on the right speaker, rotate the right speaker into place in an anti-clockwise direction and secure it using the
alignment posts.
6. Connect the speaker cable to the audio daughter-board.
Next steps
1. Install the solid-state drive interposer
2. Install the solid-state drive from M.2 slot
3. Install the solid-state drive from M.2 slot
4. Follow the procedure from step 5 to step 8 in
5. Install the solid-state drive in M.2 slot
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in

Card-reader board

Removing the card-reader board

Prerequisites
1. Follow the procedure in
42
board, if applicable.
four, if applicable.
three, if applicable.
Installing the hard
two.
After working inside your
Before working inside your
drive, if applicable.
computer.
computer.