Table of Contents
Advertisement
Figure 17
1. Forward footrest
2. Slotted screw (#6 x 1 inch) 6. Locknut (#6)
3. Washer (#6)
4. Brake sensor
4.
Loosely install the brake sensor to the
brake-sensor bracket with the 2 slotted screws
(#6 x 1 inch), 2 washers, and 2 flange nuts
(Figure
17).
5.
Align the brake sensor in or out and the
brake-sensor bracket up or down so that the
switch on the brake sensor is pressing against
the sensor plate.
6.
Complete the brake-sensor assembly installation
by tightening all of the mounting hardware.
•
Tighten the 2 slotted screws (#6 x 1 inch)
and 2 flange nuts to firmly secure the brake
sensor to the brake-sensor bracket.
Note:
Ensure that you do not overtighten
the screws. Overtightening the screws will
damage the sensor.
•
Tighten the bolts (1/4 x 3/4 inch) and 2 flange
nuts (1/4 inch) holding the brake-sensor
bracket to the front footrest to 1,017 to 1,243
N∙cm (90 to 110 in-lb).
g029762
5. Brake-sensor bracket
7. Bolts (1/4 x 3/4 inch)
8. Flange nut (1/4 inch)
Important:
After you complete the installation of
the light kit, verify that the brake sensor activates
the brake lights when the brake pedal is pressed.
Realign the brake sensor if necessary.
9
Installing the Rear Lamps
Parts needed for this procedure:
1
Left light bracket
1
Right light bracket
4
Screw (5/8 x 3 inches)
4
Flat washer
2
Jam nut (5/8 inch)
2
Rear-lamp assembly
Procedure
1.
Remove the 2 bolts, 2 washers, and 2 nuts
securing the reservoir-mounting bracket to the
left frame rail
(Figure
Note:
Stabilize the reservoir and bracket to
prevent them from falling.
1.
Reservoir bracket mounting bolts, washers, and nuts
2.
Secure the left light bracket to the bracket and
frame with 2 bolts (5/8 x 3 inches), 2 flat washers
and 2 jam nuts as shown in
11
18).
Figure 18
(Figure
19).
g023193
Advertisement
Table of Contents
