Table of Contents
Advertisement
Note:
The left and right light brackets are
different. Ensure that you use the correct mount.
Figure 19
1. Left light bracket
2. Right light bracket
3.
Mount the rear lamp to light bracket with the
bolts and nuts included with the light
Note:
Ensure that the light is positioned so that
the plug is through the hole in the light bracket
and the amber end is toward the outside of the
traction unit.
4.
Remove the 2 rear bolts and 2 washers from the
right frame rail
(Figure
Figure 20
1. Bolts and washers
5.
Secure the right light bracket to the frame with 2
bolts (5/8 x 3 inches) and 2 flat washers
19).
g023194
3. Rear lamp
(Figure
19).
20).
g023195
(Figure
10
Installing the License-Plate
Bracket
Parts needed for this procedure:
1
Plate light
1
Plate bracket
2
Screw (#10 x 5/8 inch)
2
Locknut (#10)
2
Self-tapping screw (5/16 x 1/2 inch)
Procedure
1.
Secure the plate light to the license-plate bracket
with 2 screws (#10 x 5/8 inch) and 2 locknuts
(Figure
21).
Note:
Do not overtighten the screws. Ensure
that the lens points downward and the wires are
inserted through the hole in the license-plate
bracket.
1. Locknut (#10)
2. License-plate bracket
3. Plate light
2.
Mount the license-plate bracket to the rear
bumper with 2 self-tapping screws (5/16 x 1/2
inch) as shown in
Note:
Position the license-plate bracket as
shown in
Figure
12
Figure 21
4. Screw (#10 x 5/8 inch)
5. Self-tapping screw (5/16 x
1/2 inch)
Figure
21.
21.
g023197
Advertisement
Table of Contents
