Table of Contents
Advertisement
Installing the Rear
Discharge Completion
Kit (for 72-inch Decks)
72-Inch Decks Only
1.
Loosely mount the new chambers to the
underside of the mower deck with 12 carriage
bolts (5/16 x 3/4 inch) carriage bolts and 12 nuts
(5/16 inch).
Note:
Each chamber will have 4 sets of nuts
and bolts. Position the bolt heads inside the
mower deck. Position the chambers as shown
in
Figure
8.
Note:
If a required mounting hole is not present
in the mower deck, use the new component
as a template to locate, mark, and drill the
holes (0.354-inch diameter). Only 4 holes per
chamber are used.
1. Left chamber
2. Center chamber
2.
Loosely mount the left and right chambers to
the center chamber with 2 carriage bolts (5/16
x 3/4 inch) and 2 nuts (5/16 inch) as shown in
Figure
9.
Figure 8
3. Right chamber
1. Carriage bolt
3.
Loosely mount a support strap and the left
(angled) end of the deflector to the rear angle
with 4 carriage bolts (5/16 x 7/8 inch) and 4 nuts
(5/16 inch) as shown in
Note:
Position the bolt heads next to the rear
angle.
1. Carriage bolt with nut
2. Support strap
g029610
4.
Loosely mount the rear angle with the deflector
to the mower deck with 4 carriage bolts (5/16
x 7/8 inch) and 4 nuts (5/16 inch) as shown in
Figure
10.
5.
Loosely mount a support strap and the right
(square) end of the deflector to the right chamber
with 4 carriage bolts (5/16 x 7/8 inch) and 4 nuts
(5/16 inch) as shown in
Note:
Position the bolt heads in the chamber.
6
Figure 9
2. Nut
Figure
10.
Figure 10
3. Rear angle
4. Deflector
Figure
11.
g029611
g029612
Advertisement
Table of Contents
