Toro 30667 Installation Instructions Manual page 3

2
Drilling the Mounting Holes
No Parts Required
Drilling the Holes for the
Headlights and the Wire Harness
1. Remove the nuts from the 2 carriage bolts
securing the headlights to the traction-unit frame
(Figure 1).
2. Remove the 2 self-tapping bolts securing the top
of the platform shroud to the frame
3. Unplug the headlight connectors and remove
the platform shroud from the frame
1. 6.4 cm (2-1/2 inches)
2. 8.9 cm (3-1/2 inches)
3. 14.0 cm (5-1/2 inches)
1. Platform shroud
2. Headlight assembly
(halogen shown)
(Figure 1).
3. Carriage bolt (2)
(Figure 1).
4. Drill a 38 mm (1-1/2 inch) hole in the platform
shroud in the location shown in
5. Using the dimensions in
drill 6 holes (1.0 cm) through both walls of the
roller-support tube.
Figure 2
4. 1.0 cm (13/32 inch) diameter
5. 1.9 cm (3/4 inch)
3
Figure 1
4. Self-tapping bolt (2)
5. Headlight connector
6. Drill a 38 mm (1-1/2 inch)
hole here.
Figure 1.
Figure 2, locate and
g034758
g029586