Installing The Bagger Mounting Bracket - Toro 78514 Operator's Manual

Step
1
Installing the Bagger
Mounting Bracket
Parts needed for this step:
1 Bagger mounting bracket
1 Side bracket—right
1
Side bracket—left
2 Long frame spacer
2 Short frame spacer
16 Bolt, (3/8 x 1-1/2 inches)
4
Bolt, (3/8 x 1-1/4 inches)
30 Flange Nut, (3/8 inch)
2 Stiffener bracket
8 Bolts, (3/8 x 3/4 inch)
12 Curved washer
2 Round spacers
Procedure
Important: Do not tighten any bolts until
both side brackets and bagger mounting
bracket are fit loose on the machine.
Refer to Tightening the Mounting Bolts for
the correct procedure to tighten the bolts.
1. Install the side brackets to the bagger mounting
bracket (Figure 3).
2. In the top two holes, install 2 bolts (3/8 x 1-1/2
inches), 2 flange nuts (3/8 inch), 2 long frame
spacers, and one short frame spacer (Figure 3).
Note: Make sure the long frame spacers are
installed as shown in Figure 3).
3. In the bottom hole, install a bolt (3/8 x 1-1/4
inches) and a flange nut (3/8 inch) (Figure 3).
4. Install a bracket stiffener to the side bracket
and bagger mounting bracket. Use 4 bolts
(3/8 x 3/4 inch) and 4 flange nuts (3/8 inch)
(Figure 3).
5. Repeat the previous steps for the opposite side
(Figure 3).
Figure 3
1. Bagger mounting bracket
2. Bolt, (3/8 x 1-1/4 inches)
3. Flange nut, (3/8 inch)
4. Bracket stiffener
5. Left side bracket
6. Bolt, (3/8 x 3/4 inch)
6. Remove the bolts, nuts, and washers holding
the roll bar to one side of the machine. Discard
the nuts, bolts, and washers (Figure 4).
7. Install the bagger side plate and the roll bar
section to the side of the machine using 4 bolts
(3/8 x 1-1/2 inches), 4 curved washers (3/8
inch), and 4 flange nuts (3/8 inch) (Figure 4).
8. Repeat the steps above for the opposite side
(Figure 4).
Note: Make sure the curved washer are
installed as shown in Figure .
7
7. Long frame spacer
8. Bolt, (3/8 x 1-1/2 inches)
9. Short frame spacer
10. Right side bracket
11. Use these holes in the
bracket stiffener