Toro 30667 Installation Instructions Manual page 15

Figure 27
1. Platform shroud
2. Halogen headlight
3. Carriage bolt and nut
4. Washer-head screws and
nuts
13. Secure the shroud and the headlights to the
frame with the 2 carriage bolts and nuts you
previously removed
14. Route the wire harness to the column-bracket
assembly on the steering column.
15. Plug the connectors into the flasher module,
horn, turn signal, and hazard switches
28).
5. Headlight wire connectors
6. Hole for wire harness
7. LED headlight
(Figure 27).
(Figure
1. Turn signal connector
2. Horn connector
16. Install the cover onto the column-bracket
assembly with 2 hex socket button-head screws
g312120
as shown in
1. Cover
17. Secure the wire harness to the column using the
cable tie inserted into the slots in the column
mount bracket; refer to
18. Route the right rear wire harness under the right
side of the traction unit to the right, rear light
(Figure 30).
15
Figure 28
3. Hazard connector
4. Beacon connector
Figure 29.
Figure 29
2. Hex socket button-head
screws
Figure 14.
g312684
g034566