Table of Contents
Advertisement
11
Installing the Wire Harness
Parts needed for this procedure:
1
Wire harness
1
Switch-panel-enclosure cover
3
Screw (#10 x 1/2 inch)
3
Mounting pad
11
Cable tie
2
Jumper wire harness (LED headlights only)
Procedure
Use the following instructions and illustrations to route
and connect the wire harness.
Figure 22
1.
Remove the flange-head screw securing the
compartment clamp and seal to the traction unit
(Figure
23).
Note:
Remove the clamp and seal to gain
access to the fuse compartment.
1. Compartment clamp
2.
From under the right side of the traction
unit, route the fuse-block section of the wire
harness up to and into the opening in the fuse
compartment
g034565
Important:
do not pull it across sharp edges, which may
damage the wires. Wires must not contact
hot or moving parts. Secure the wire harness
with cable ties.
3.
Mount the wire-harness-fuse block next to the
existing fuse block with the 2 self-tapping screws
(#8 x 1/2 inch) included with the wire harness
(Figure
25).
Note:
Do not overtighten the screws.
4.
Connect the small-ring terminal from the wire
harness to 1 of the screws on the ground-block
terminal
(Figure
13
Figure 23
2. Seal
(Figure
24).
Figure 24
When routing the wire harness,
25).
g023198
g029803
Advertisement
Table of Contents
