Drilling the Mounting Holes in the
Rear Bumper for the License Plate
Using the dimensions shown in
drill 2 holes (9/32 inch) through the outside wall of the
rear bumper.
1. 8.3 cm (3-1/3 inches)
2. 13.3 cm (5-1/4 inches)
Figure
5, locate and
Figure 5
3. 52.07 cm (20-1/2 inches)
4. Drill a hole (9/32 inch)
here.
3
Installing the Headlights
Parts needed for this procedure:
1
Right headlight bracket
1
Left headlight bracket
6
Bolt (3/8 x 2-1/2 inches)
6
Flange nut (3/8 inch)
8
Washer (3/8 x 7/8 inches)
2
Rubber hanger
4
Spacer
4
Bolt (5/16 x 1-5/8 inches)
4
Flange nut (5/16 inch)
1
Right headlight assembly
1
Left headlight assembly
2
Bent-plate bracket
Installing the Headlight Bracket to
g029755
a ROPS Model
1.
Fasten the left and right headlight brackets to
the front of the roller-support tube with 6 bolts
(3/8 x 2-1/2 inches) and 6 flange nuts (3/8 inch)
as shown in
1. Installed headlight bracket
2. Bolts (3/8 x 2-1/2 inches)
Note:
Position the bolts so that the flange nuts
are toward the front of the traction unit.
2.
Fasten the left and right headlights to the
headlight brackets
supplied with the lights.
5
Figure
6.
Figure 6
3. Headlight bracket
4. Flange nuts (3/8 inch)
(Figure
7) with the fasteners
g029788