Weighing With Tolerance Range (Check Weigher); Input Of The Limiting Values By Weighing (See Point 6.1 „Mode Weighing") - KERN 470 Series Operating Instructions Manual

7 Weighing with tolerance range (Check weigher).

This balance can be used as dispensing balance as well as grading balance. The
respective lower and upper limiting values can be memorised.
This is possible in all four modes:
6.1 WEIGHING
6.2 Weighing and parts counting
6.3 Weighing and percent
6.4 Weighing and conversion
For 6.2 up to 6.4 firstly the starting extents have to be set, i.e. the reference number,
100 % reference weight and conversion factor, the limiting values in the sense of point
7.1 „Input of the limiting values by weighing".
Important!
Input always firstly the lower limiting value,
only then input the upper limiting value.
7.1 Input of the limiting values by weighing (see point 6.1 „Mode weighing")
Press S and release it when
Now flashing display of either
Put the lower (i.e. the smaller) limiting value on the weighing plate.
Confirm with F, the memorising will need a short time. Now
flashing.
Put the upper (i.e. the greater) limiting value on the weighing plate.
Confirm with F and wait for the beep.
Now both limiting values are memorised.
When the succeeding weighings will be within the tolerance range, i.e. between the lower
and the upper limiting value, an acoustic sign will optionally come out. The acoustic sign
stops when the tolerance range has been left. (More options for weighing with tolerance
range see 10 „General programmations".)
470-BA-defs-0017
L. SEt appears.
0 or of the actual memorised lower limiting value.
0 appears again
43