9.2 Adjusting for verification
9.2.1 General
Before the verification procedure, the balance must be adjusted where it is to be used.
The commutation of the readout, to 01 g for the verifiable balances 470-38
and 470-44.
The balances have the following standard settings:
KERN
Readout (d)
The readout has to be modified for the verification as follows:
Press F and release it when Func appears.
Then
1 Set. 1
By pressing repeatedly F start the function 72.d.A 1 of.
Model 470-38:
Model 470-44:
Confirm with S and leave the programming mode.
9.2.2 Disable/enable the adjustment function
Remark:
An adjustment is only possible if this has not been disabled by the
adjustment switch.
Switch up:
Switch down:
48
470-38
0,02 g
appears.
Press TARE and release it when 72.d.A 3 appears
(Division 0,1 g).
Press TARE and release it when
(Division 0,1 g)
Adjustment function is possible.
Adjustment function is disabled. Jafter the succesful
adjustment where the balance is being used,
adjustment must be disabled with this switch
position.
470-44
0,05 g
74.d.A 3
72.d.A 2 appears
74-d.b 2
470-BA-defs-0017