Selection Of The Mode Setting; Mode Setting „Weighing; Weighing - KERN 470 Series Operating Instructions Manual

6 Selection of the mode setting

There are four mode settings::
Mode settings
6.1

Weighing

6.2 Weighing and parts counting
6.3 Weighing and percent
6.4 Weighing and conversion
• Manufacturer's default.
The mode setting is kept even when the balance will be turned off.
In each mode setting weighing, pieces and percent presets with tolerance range are
possible point 7 „Weighing with tolerance range".
In each mode setting accumulations of weight values, pieces and percent values are
possible , see pint 9 "Accumulation of indicated values".
6.1 Mode setting „Weighing"
Setting see point 10 „General programmations" on mode setting „1 Set 1".
6.1.1 Weighing
Turn on the balance with the switch at the bottom of the right side of the casing. All
segments and signs will appear in the display in the frame of the self-controlling.
Then the indication changes to
To secure the accuracy we recommend a warming-up time of minimum 15 minutes.
Only now (!) place the weighing object on the weighing plate. Take care that the
weighing object does not touch anywhere at the casing or at the base.
The weight determination is finished when the small ring
appears in the left upper corner of the display.
Read the weighing result.
470-BA-defs-0017
Indication
1 SEt 1*
1 SEt 2
1 SEt 3
1 Set 4
0. Now the balance is ready for use.
Page
37
39
40
42
o (=stability detector)
37