Delay Trails - GigRig G2 User Manual

Delay Trails

Another amazing function of G2 is the ability to have your delay 'spillover' into the next preset using a
built in mixer in combination with our Post Gain amplifier. You can have your delay in either loop 9 or 10
There are 3 easy steps to set this up
1. First you must move the Post Gain amplifier AFTER loop10 by holding down footswitch 5 then
pressing PHASE. You'll see the Effects Loop lights flashing. Now press the effects loop 10.
2. You can have trails on loops 9&10, which is great if you're using reverb and delay. To choose
trails on loop 9, simply hold footswitch 9 down and press the PHASE button. Repeat using
footswitch 10 to turn on trails for footswitch 10. Holding down footswitch 11 and pressing the
PHASE button will clear any connections to the mixer.
3. Your trails function is now ON. To set up a sound with trails you must have the Post Gain
amplifier selected in the sound where you want trails. For example, choose a sound that uses
your delay, and then go to a sound with the Post Gain selected, and you will hear the echo trail
over the new sound. If you go to a sound WITHOUT the Post Gain selected, the sound will have
no trails. His way you can choose which sounds will have trails and which ones won't.
Trails works by using G2's built in mixer. If you go from a preset using loop 9 or 10 to one that doesn't,
the output from the spill over loops will be connected to one side of the mixer while the guitar signal is
connected to the other.
If I use loop 9&10 together, loop 9 will continue to feed into loop 10 which then feeds into the mixer
Remember, the Post Gain amp must be AFTER the loop with your delay in to use trails .
© TheGigRig Ltd 2013
1 8