GigRig G2 User Manual page 29

Your G2 will remember this amp position setting even when powered off.
SF6- Test Mode. All lights, all relays and all circuits are switched on. The G2 should then take
the maximum current from the supply which is about 500mA. This is a good test and is strongly
advised if you are not using TheGigRig Generator to power the pedal board. Dimming or
resetting would be obvious signs of weak unsuitable power.
SF7- Midi Setup. This enters a Midi setup mode so each foot switch can send out its program
change code on any of ten available Midi Channels.
You can set Midi on each foot switch to send its foot switch program number on up to three
separate channels to control thee separate pedals or amplifiers etc. See MIDI section 10 for
more details.
SF8- Mono/Stereo - This toggles the function of the stereo RIGHT input on loop 9. This special
function changes this input from a conventional stereo return to a guitar input that will mix
another guitar or pedal with the out-amp. This function is memorized by your G2.
This mixer input is only active when the output amp is selected; it can be used to mix in other
guitars, drum machines or pedals into your system. (High quality low noise mixer)
SF9- Loop 9 Trails/Spillover. Loop 9 trails (delay spillover) on/off. This toggles the function of
the stereo LEFT input on loop 9. This special function changes this input from a conventional
stereo return to mix stereo trails into the out-amp. This function is memorized by your G2 until
you power on again holing down foot switch 9.
Note to use trails you must have the output amp selected in your signal path,
SF10- Loop 10 Trails/Spillover. Loop 10 Trails (delay spillover) on/off. This toggles the
function of the stereo LEFT input on loop 10. This special function changes this input from a
conventional stereo return to mix stereo trails into the out-amp. This function is memorized by
your G2 until you power on again holing down foot switch 10.
(Note to use trails you must have the output amp selected in your signal path, AND it must be
placed AFTER the delay loop, so after 9 or 10. To do this power up holding down footswitch 5,
then press 9 or 10 to reposition the output amp.)
SF11- Mixer Reset. This will turn off the Mixer and Trails functions on loops 9 and 10. It will
switch off all mix inputs and trails functions to the original factory defaults. No other settings or
patch parameters are changed or lost.
SF12- Midi Thru ON. This function will switch ON midi 'through'.
SF13- Midi Thru OFF. This function will switch off midi through for two-unit operation. In the
default mode a midi in signal will activate a foot switch and then the foot switch will send its
program change command to the midi out.
In some configurations when two G2 systems are connected midi through needs to be switched
off.
Note this midi through is filtered; only foot switch program changes will go through to the midi
out. In this mode pressing a foot switch with your foot will still send a midi output
© TheGigRig Ltd 2013
2 8