Table of Contents
Advertisement
G2 can send midi control message as a tap tempo midi output.
This function is designed to work on foot switch 7.
Instead of sending a program change message, just once; foot switch 7 can be set to send a
CC message in time with every tap of the switch.
A CC message will be sent to the midi out in time with your foot switch press. In single mode
and on each press in stomp mode)
This tap tempo output can be switched on or off in all eight banks separately.
To activate CC tap tempo output, go to SF3 (this is Special Function Footswitch 3, so press and
hold footswitch 3m then press the PHASE button). Press loop1 to 'on' or any other of the loops,
to tell G2 what CC messages should be sent. See below.
Here is a list of the pedals supported so far:
1 Strymon TimeLine/Eventide H9/Source Audio Nemesis/Chase Bliss Audio Tonal Recall -
#cc 93 (any value) CH2
2 Eventide TimeFactor - #cc 80 (value 127) CH2
3 DD500 - #cc 84 (any value) CH2
4 Moog analog/supa delay #cc 114 (any value) CH2
5 H9 - assign #cc 93 to tap tempo CH2
6 Line 6 M series #cc 64 CH2
7 Pigtronix Echolution Tap Tempo - #25
8 RESERVED
Whilst in SF3 you can use the loop buttons to select the required pedal from the list above. You
can also use the ENGAGE button to set the CC messages in other banks. Press Phase to
escape as usual.
When foot switch 7 is pressed its light will flash if any CC message has been set to 'on' in the
current banks.
To indicate that this mode is activated, foot switch 7's will flash at 100 beats per minute, but
please note the speed of the flashing led will not change in relation to the tempo tapped in.
Combined with the CC messages you can send up to three program changes each time you
stomp on foot switch 7. This is achieved by selecting stomp mode and selecting up to three midi
outputs using SF7.
If you just want the CC message and nothing else, then switch on stomp and using SF7 (see
© TheGigRig Ltd 2013
2 2
Hide quick links:
Advertisement
Table of Contents
