Table of Contents
Advertisement
THE ADVANCED SWITCHING SYSTEM
With G3, you can reorder your effects loops in any order you like. To do so:
5.2.5 STOMPBOX –
See Section 4.2
5.2.6 TRAILS
THE GIGRIG G3 USER MANUAL
a. Go to LOOP ORDER on the Deep Edit menu.
b. Scroll right
(4) and you will see Loops 1-12 which correspond to your
effects loops.
c. Use the EFFECTS LOOPS push buttons along the centre of G3 to rearrange
the order of the loops, as desired.
The numbers will change positions to reflect the order chosen.
For example, here is a modified loop order. The loops are arranged as follows:
8,6,3,11,5,2,7,1,9,10,11,12
To activate TRAILS on a preset:
a. Select the preset you want your Reverb and Delay Trails to spill-over onto.
b. Go to TRAILS in the menu.
c. Select trails control
d. Select trails, loopl then set the required loop(s) to 'trails in'
Remember, you set up Trails on the preset you are going to, not the preset
that you have come from.
5.2.7 PARALLEL
(4), set to 'trails enabled'
21
Advertisement
Table of Contents
