Software; Factory Restore - GigRig G2 User Manual

SF14- Hidden Preset Mode - toggles second press bypass on all foot switches. This function is
programmable PER BANK, so you can decide if you want the hidden preset to be active on all
banks or just a select few.

Software

G2 uses TheGigRig advanced pedalboard operating system, PBOSXX1, which remembers
every button press on every one of the 120 presets. It also remembers each and every pre-gain
and post-gain volume setting for all 120 of these presets and much more.
To make sure you can't go wrong it also stores all your settings for over 40 years, even with the
power switched off!
Designed using the same techniques as aircraft software, for freeze free reliable operation, it
makes sure you don't lose your settings. Even if the power is lost in the middle of changing a
patch it will remember your last action.
It also watches your settings and if you try to do something that would be confusing or just
wrong, it won't let you progress.
Designed for simplicity on the surface and complex functions underneath; all you need are a
couple of facts and you are ready to go.
* You don't need to look for a save button - there isn't one. Everything is saved as you go along.
* If a button does not respond, you need to look at the Stomp Light. To edit a patch you must
exit stomp mode. Exit stomp mode by turning off the yellow stomp light and then press the foot
switch you want to edit. After editing you can turn the stomp light back on again.

Factory Restore

Your G2 can be returned to its factory settings at any time. All the memories and therefore all
your patch settings will be lost. Following the instructions below will completely remove all your
patch and volume setting from all corners of the G2s memory.
THIS PROCEDURE WILL CLEAR ALL STORED SETTINGS
To clear the G2 and return the unit to its factory defaults, remove the power then hold down foot
switch 2 whilst you reconnect the power. The G2 will not power on as normal, instead it will flash
TheGigRig Logo. You can still change your mind and abort this total reset by removing the
power plug again; however, if you are absolutely certain you want to lose all your settings and
return the unit to its factory defaults, whilst the logo is flashing hold down foot switch 3. Your G2
will flash and go to bypass; all memories are now re-written. Remove and re apply power as a
final procedure.
All settings have now been lost and your G2 is exactly the same as the day it left our factory.
© TheGigRig Ltd 2013
2 9