Post Gain Functions; Insert Loop; Movable Insert - GigRig G2 User Manual

9. P G
OST AIN

Insert Loop

The Volume Insert Loop is connected to the Post Gain circuit and is turned on whenever you activate the
Post Gain amplifier. With nothing plugged to the Insert Loop the Post Gain will simply amplify your signal
at the output but when you connect to the Volume Insert the signal from the Post Gain is routed to the
Insert. This gives you some really fantastic options.
1. Use any volume pedal, passive or active with no tone loss. Simply set the maximum level using
the post gain buttons on the front panel and the low impedance Post Gain circuit will drive the
Volume Pedal.
2. Use the Insert to connect to your amplifiers FX Loop. This makes using your amplifiers effects
loop so easy, and you don't have to give up a loop in G2 to do it. And as this loop is movable,
you can place this insert after ANY G2 effects loop you like.

Movable Insert

That's right, you can place the insert after ANY effects loop you like using SF5. Not only that but you can
change that position for each bank of 8 presets. If you want your volume pedal after your Overdrives,
then place the insert AFTER your OD's. Want your delay pedal in your amp's FX loop? Simply place the
insert before your delay pedal. Easy
Here's how it works
Your G2 is shipped with POST GAIN after loop 10, but if you place it after loop 8 it will look like this.
© TheGigRig Ltd 2013
F
UNCTIONS
1 6