Mounting On Din Rails - Siemens SIMATIC IOT2050 Operating Instructions Manual

3.2.2.2

Mounting on DIN rails

Mounting
1. Place the device and rail clamp on the upper edge of the standard profile rail at the
position shown and push the device down.
2. Swing the rail clamp of the device from below through the standard profile rail.
3. Push the device in the direction of the standard profile rail. You will hear the device click
into place.
Vertical
Removing
1. Push down the device until it is released by the rail clamp.
2. Swing the device out of the standard profile rail.
3. Lift the device up and off.
SIMATIC IOT2050
Operating Instructions, 03/2020, A5E39456816-AA
Installing and connecting the device
3.2 Mounting the device
Horizontal
21