Mounting On Din Rails; Secure The Mounting Clips - Siemens SIMATIC IOT2050 Operating Instructions Manual

Fasten securely
NOTICE
Insufficient load carrying capacity
If the mounting surface for wall mounting does not have an enough load-bearing capacity,
the device may fall and be damaged.
Ensure that the mounting surface on the wall can bear four times the total weight of the
device, including fixing elements.
NOTICE
Incorrect fixing elements
If you use anchors and screws other than those specified below for wall mounting, safe
mounting is not guaranteed. The device can fall and may be damaged.
Only use the anchors and screws specified in the following table.
Material
Concrete
Plasterboard,
(at least 13 mm thick)
Metal,
(at least 2 mm thick)
3.2.2

Mounting on DIN rails

3.2.2.1

Secure the mounting clips

Requirement
● The DIN rail is installed at the installation site (35 mm standard profile).
● Mounting bracket and mounting clamps
● Two screws
● T8 screwdriver
SIMATIC IOT2050
Operating Instructions, 03/2020, A5E39456816-AA
Bore diameter
Select according to the speci-
fication of the mounting ele-
ments used
Installing and connecting the device
3.2 Mounting the device
Fixing element
Anchor, ∅ 6 mm, 40 mm long
•
Screw, ∅ 4 mm, 40 mm long
•
Toggle plug, ∅ 12 mm, 50 mm
long
Screw M4 × 15
•
M4 nut
•
19