Outlander Full - Hold-Down Arm Adjustment - Harmar Mobility PARAGON OUTLANDER Series Installation & Service Manual

4. Adjust the top nut, so the top of the nut
measures 21/4" to 2 1/2" above the top of the
hold-down arm. Once the measurement has
been set, DO NOT adjust the top nut or the
stationary nut. See Figure 6-4.
CAUTION
!
If the hold-down foot is set too loose, the foot
may not have enough pressure to hold the
scooter down. If too tight, the foot may cause
damage to the scooter and/or lift.
Figure 6-4
5. Lower the platform about 5" to relieve pressure
from the scooter's deck. While holding the
stationary nut in place, run the bottom nut up to
the hold-down arm and tighten. See Figure 6-5.
Tighten
Hold in Place Tight
Figure 6-5
OUTLANDER VEHICLE LIFTS: SECTION 6
OUTLANDER FULL - HOLD-
DOWN ARM ADJUSTMENT
Top of the Nut
2 1/4" to 2 1/2"
Top of
Hold-Down Arm
Outlander Vehicle Lifts:
LIFT ADJUSTMENTS
CAUTION
!
Do not rotate the stationary nut; otherwise, it
will change the pressure that was previously set.
1. Position the chair onto the platform after the
wheel chocks have been set. See Figure 6-6.
Figure 6-6
2. Raise the platform to top of travel until you hear
the motor clutch. See Figure 6-7.
Figure 6-7
Installation & Service Manual
27DEC19 | 630-00133 REV A
21