Hold-Down Arm Installation - Harmar Mobility AL003 Installation & Owner's Manual

AL003: SECTION 4
INSTALLATION
Measure from Hitch Bar to ground
NOTE: If inverting/flipping the ball mount for better
height, the ball mount and swing brackets must be flipped
together. See Figure 4-2.
Orientation of these parts is important for the tilt away
feature limits.
OR
HOLD-DOWN ARM
INSTALLATION
INSTALL
HOLD
DOWN
ARM
ADJUST TO
DESIRED HEIGHT
TIGHTEN
SET
SCREWS
AL003: Installation/Owner's Manual
8
22DEC2021 | 630-00096-B
AS SHIPPED
8-12"
ORIENTATION OF Class 1, 2, 3, and 5 HITCH ADAPTERS IS IDENTICAL
SWING
BRACKET
Figure 4-2
REMOVE,
REMOVE,
FLIP,
MOVE UP,
RE-ATTACH
RE-ATTACH
12-16"
10-14"
Hold-down arm height can be adjusted so that the
wheelchair's armrests clear the hold-down arm
when loading onto the tilted platform.
When the platform is tilted upright, the wheelchair's
should barely contact the bottom of the hold-down
arm. See Figure 4-3.
The knob on the hold-down arm can be turned to
adjust the pressure on the wheelchair's armrest.
See Figure 4-4.
REMOVE,
FLIP, MOVE UP,
RE-ATTACH
14-18"
Figure 4-3
Figure 4-4