Harmar Mobility PARAGON OUTLANDER Series Installation & Service Manual page 22

OUTLANDER VEHICLE LIFTS: SECTION 6
LIFT ADJUSTMENTS
3. Rotate arm to locked position over the seat.
Loosen the two bolts and nuts in the back of
the vertical tube. See Figure 6-8. Allow the arm
assembly to lower until the arm contacts the
seat.
Figure 6-8
4. Lower the platform approximately 2" to 3"
and allow the arm to drop along with the seat.
Retighten the two bolts and nuts. Figure 6-9.
Lower
2" - 3"
Figure 6-9
5. Run the lift up until the top of travel and when
you hear the clutch.
Outlander Vehicle Lifts:
22
27DEC19 | 630-00133 REV A
Installation & Service Manual
NOTICE
You can alter the position of the arm by removing
the top shaft collar, retracting the T-handle and re-
inserting the arm from above or below.
See Figure 6-10.
Replace Shaft Collar
Figure 6-10
This method allows the T-handle to remain on the
same side as the key and toggle switches. If you wish
to have the T-handle on the opposite side as the key
and toggle switches, you can flip the entire assembly.
NOTICE
Verify that the hold-down arm produces enough
pressure on the seat to hold the power chair firmly
on the platform. The seat should be somewhat
indented by the arm. See Figure 6-11.
Figure 6-11
Higher or lower arm settings can
be achieved by removing the top
shaft collar, retracting T-handle,
and re-inserting arm from above
or below.