Chair Preparation; Anchor Plate - Harmar Mobility PARAGON OUTLANDER Series Installation & Service Manual

OUTLANDER VEHICLE LIFTS: SECTION 5

CHAIR PREPARATION

Section 5
Chair Preparation
A lift with securement straps offers two options for
attaching strap hooks to chairs that do not already
have tie-down loops—the anchor plate or the U-bolt
kit. Both options are available upon request.

ANCHOR PLATE

The anchor plate is a flat plate and may vary in length
depending on the mobility device used. The anchor
plate attaches to the bottom of any chair or scooter
that has a center seat post. See Figure 5-1.
Figure 5-1
The anchor plate should extend about 11/2" out from
the side of the cushion. To secure the chair to the
lift, the user can attach the strap hooks to the anchor
plate. See Figure 5-2.
Figure 5-2
Outlander Vehicle Lifts:
18
27DEC19 | 630-00133 REV A
Installation & Service Manual
Anchor Plate Installation
1. Remove the seat from the chair.
2. Loosen the screws that attach the plate to the
bottom of the seat. Allow enough room to slide
the anchor plate between the seat and the seat
plate.
3. Attach the anchor plate to the center of the
seat plate with the holes on each end extending
evenly on each side of the seat.
4. Retighten the screws that hold the seat plate to
the bottom of the seat.
5. Replace the seat on the chair.