Manual Override - Harmar Mobility PARAGON OUTLANDER Series Installation & Service Manual

PROBLEM
Extra length of wire leads to
the lift motor.
The lift does not reach the
ground.

MANUAL OVERRIDE

In the event of a power failure (for example, if your
car battery dies), you can still operate the lift using the
manual override system.
WARNING
!
Always disconnect the power from the lift by
unplugging the two connector plugs before
attempting to use the manual override to avoid
electrical shock.
1. Unplug power to the lift. See Figure 7-3.
Figure 7-3
2. Using a coin or key, remove the cap on the top
of the motor cover. See Figure 7-4.
OUTLANDER VEHICLE LIFTS: SECTION 7
CAUSE
Wire was provided for the
optional swing-away.
The incorrect hitch
adaptor was installed.
Outlander Vehicle Lifts:
TROUBLESHOOTING
SOLUTION
The extra wire is provided in case a swing-away option
is used with the lift. If a swing-away is not installed, coil
the extra wire and zip-tie it to the frame, out of the way
of any moving parts. Leave the extra wire in case you
need a swing-away installation in the future.
Check the attachment of the hitch adaptor to the
hitch post on the back of the lift. See Hitch Adaptor
Installation on page 14. The normal range of lift
operation is 5" to 16" to the bottom of the hitch
receiver of the vehicle. Any higher vehicles will require
a different hitch adaptor.
Figure 7-4
3. Insert a 3/8" socket wrench into the actuator and
rotate the hex shaft. See Figure 7-5.
Turn COUNTER-
CLOCKWISE to
LOWER platform
Figure 7-5
Installation & Service Manual
27DEC19 | 630-00133 REV A
Turn CLOCKWISE to
RAISE platform
25