Refilling The Envelope And Tape Sealant Bottle - Pitney Bowes Connect+ Series Operator's Manual

Maintenance

Refilling the envelope and tape sealant bottle

Pitney Bowes recommends using E-Z Seal® Sealing Solution because it helps keep your moistener tank
clean and improves sealing performance. Refill the sealant bottle when your E-Z Seal® Sealing Solution
is running low.
Your mailing system displays a message telling you when your E-Z Seal® Sealing solution is running
low. When you receive this message, your system can still seal approximately 50 envelopes.
1. Lift the sealant bottle out of the cradle. The bottle is located to the right of the printer module,
behind the stacker.
2. Remove the cap from the bottle.
3. Add enough E-Z Seal® Sealing solution to bring the level up to the bottom of the throat of the
bottle. Do not overfill the envelope sealant bottle.
4. Replace and tighten the cap and return the bottle to its original position.
Pitney Bowes Operator Guide February, 2018 Page 247 of 349