ADJUSTINg CLUTCH PEDAL
(1).Clutch.rod
(A).Free.play
1..Stop.the.engine.and.remove.the.key.
2..Slightly. depress. the. clutch. pedal.
and. measure. free. travel. at. top. of.
the.pedal.stroke.
3..When. adjusting,. remove. the. split.
pin. and. turn. the. U-joint. within. ac-
ceptable. limits. of. the. clutch. pedal.
to.adjust.the.rod.length.
4..Tighten.the.mounting.nut.again.and.
remove.the.split.pin.
Proper brake pedal free play (A)
20.to.30.(0.78~0.18in.).mm.
at.top.of.pedal.stroke.
LX500_en_om_10.indd 9
REPLACINg HYDRAULIC OIL FILTER
t91Oa29a
(1).Hydraulic.Oil.Filter
1. To drain the used fluid, open the
drain.plug.at.the.bottom.of.the.clutch.
housing.and.transmission.case.and.
drain.the.oil.completely.
CAUTION
To avoid personal injury:
•
Be sure to stop the engine before
changing oil filter cartridge.
•
Allow engine to cool down suf-
ficiently, oil can be hot and can
burn.
PERIODIC.SERVICE
S76Oa13a
(1).gauge.
.
(3).Bleeder.Plug
(A).Oil.level.is.acceptable.within.this.range.
2..After. draining,. reinstall. the. drain.
plug.
3. Remove the oil filter.
4. Apply a film of clean transmission
fluid on the rubber seal of a new
filter.
5. Tighten the filter firmly until it con-
tacts.the.mounting.surface..Tighten.
the filter by a hand an additional half
turn.only..
10
-
S76Oa15a
(2).Oil.Filling.Plug
10
2012-11-27 오후 2:57:07