Connectors For The Upper Cable Management Arm - IBM Storwize V5000 Gen2 Quick Installation Manual

Figure 43. Connectors for the upper cable management arm
1 Inner connector on the upper CMA
2 Connector base on inner rail member
3 Outer connector on the upper CMA
4 Connector base on outer rail member
5 Support rail connector on the upper CMA
6 Connector base on outer rail member
1. Press the latch on the connector base on the upper CMA assembly (
2. Pull the connector to remove it from the connector base on the right support rail (
page 51).
3. Press the latch on the outer connector of the upper CMA assembly (
4. Remove the outer connector from the inner member of the left support rail (
51).
5. Remove the inner connector of the upper CMA assembly (
support rail ( 2 ), as shown in Figure 43 on page 51.
Remove the lower CMA assembly
Note: The procedure for removing the lower CMA assembly is the same as the procedure to remove the
upper CMA assembly. However, the connector locations are reversed. For example, the connector base of
the upper CMA ( 5 in Figure 43 on page 51) connects to the right rail. The connector base of the lower
CMA ( 11 in Figure 44 on page 52) attaches to the left rail.
5 in Figure 43 on page 51).
3 in Figure 43 on page 51).
4 in Figure 43 on page
1 ) from the inner member of the left
Chapter 2. Installing the system hardware 51
6 in Figure 43 on