Installing Or Replacing The Fascia: 2077-92F; Fascia Components On The Expansion Enclosure - IBM Storwize V5000 Gen2 Quick Installation Manual

9. If needed, reconnect the power cables to the expansion enclosure, as described in "Powering on the
5U expansion enclosure: 2077-92F " on page 108.
10. Check the LEDs on the top of the secondary expander module to verify that it is receiving power.
" Storwize V5000 2077-92F expansion enclosure LEDs and indicators" on page 112 describes the
status indicated by the LEDs.

Installing or replacing the fascia: 2077-92F

During the initial installation process or after you perform service, you can install the fascia components
on the front of a 2077-92F expansion enclosure.
About this task
The 4U fascia covers the display panel of the expansion enclosure. It is attached to the enclosure by four
screws. The bottom 1U fascia covers both of the power supply units (PSUs) on the enclosure. As Figure
68 on page 66 shows, the fascias are independent; you can remove or replace one without having to
remove or replace the other.
Figure 68. Fascia components on the expansion enclosure
Note: When the expansion enclosure is shipped, the 4U and 1U fascia are not installed. You must install
them as part of the initial installation process.
Procedure
Attach the front (4U) fascia
1. Align the front 4U fascia with the enclosure so that the thumbscrews go through the holes on each
side. As Figure 69 on page 67 shows, this action aligns the screw holes on the back of the fascia with
the screw holes on the front flange of the enclosure.
2. Replace the four screws to reattach the 4U fascia. Secure the screws from the back of the flange and
into the rear of the fascia. Each side of the 4U fascia contains two screws.
Attach the bottom (1U) fascia
66 Storwize V5000 Gen2: Quick Installation Guide