Zoom X5v Technical Reference page 35

Hide thumbs Also See for X5v:

Table of Contents

At the top of the page, there are at least three route table entries.

(These entries are automatically displayed once you connect the

X5v or V3.) Under Destination, you will see the IP address of the

X5v or V3's LAN interface (for example, 10.0.0.0), the IP address

of the local loopback test (127.0.0.1), and the IP address of the

WAN interface (for example, 192.168.1.1). Under Netmask, you

will see the corresponding subnet masks for these Destinations.

Under Gateway, you will see the corresponding Gateway IP

addresses. The Interface field denotes the type of interface; for

example, br0 denotes Ethernet, lo0 denotes loopback, and ppp1

denotes PPP (WAN).

Use the following table to configure a new route:

Entry

Explanation

Destination

IP address of the network or subnet.

Netmask

Subnet mask address that corresponds to the

Destination's IP address.

Gateway

IP address of the Gateway that is on the same network

or subnet as the X5v or V3.

Select this option if you want to enter a static IP

Specify IP

address. If you need help determining the Gateway's IP

address, at the Gateway computer's command prompt,

type ipconfig /all.

Select Interface

Select an interface type from the list.

Table of Contents