Maintenance And Cleaning; Grease Filter - Kernau KBH 07601 X Manual Instruction

of electric cookers and not less than 65cm in the case of gas or electric-gas cookres. If the
heating appliance manual instruction indicates a grater insteallation distance for the kitchen
hood, please follow these indications.
The hood should be installed in the following order:
1. Prepare the cabinet for mounting the hood:
- for cabinets with a width of 596mm "60", remove the bottom of the cabinet.
- for cabinets with a width of> 596mm, cut a hole in accordance with Figure S3.
2. Remove the aluminum grease filter figure S1.
3. Carefully slide the hood into the previously prepared cabinet, hold the hood with one hand
or ask an additional person for help. Screw in the screws by selecting one mounting option:
A-fixing to the cabinet side walls, B-fixing to the top of the cabinet.
4. Install the aluminum grease filter previously removed.
When installing the hood, obey the general regulations regarding the discharge of air
from the room. It should be taken into account that the use of spiral aluminium pipes limits
the hood's efficiency and increases the volume of air flowing.
Before undertaking any operations related to the maintenance of the device,
disconnect the hood from the power supply network. The device should be washed with
specialized agents for surfaces made of stainless steel. The hood should be cleaned with mild
agents, do not use abrasives. Regular maintenance will improve the operation of the hood.
DO NOT USE ALCOHOL !
CAUTION!
Failure to comply with the regulations regarding cleaning of the device and replecement of
filters creates the risk of fire. It is therefore recommended to follow the given instructions.
The manufacturer is not responsible for any damage to the engine or fires resulting from non-
compliance with the maintenance rules and the instructions mentioned above.
The hood is equipped with an aluminum filter. The filter is removed by moving the
locks in the direction shown by the arrow (figure S1). The filter should be washed by hands
as follow: by immersing it in water with a liquid at a temperature of 40-50oC for 15 minutes.

Maintenance and cleaning

Grease filter

16