Carbon Filter; Replacement Of Lightening; Mechanical Control - Kernau KBH 07601 X Manual Instruction

After the 15 minutes, start washing and rinse the filter thoroughly. The filter must be
completely dry before placed in the hood again. A filter that is not cleaned regularly reduces
hood efficiency an can cause fire. When washing in the dishwasher, filter may change color
or discolor, but this does not affect its filtering properties.
The hood may be equipped with the carbon filters. Carbon filters are use only when
the hood is not connected to the ventilation duct. Filters should be instaled on turbin housing
as shown figure S5. In this case, the purified air is forwarded back to the room. The hood
should not be connected to the ventilation ducts. In order to ensure proper hood operation
and effective odor absorption, the carbon filters should be repalced regulary (every 3 to 6
months) depending on the intensity of use of the hood. The carbon filter is not a standard
equipment of the hood ant it is an additional paid option.
Before undertaking any operations related to the replacement of lightbulbs, the hood
should be disconnected from the power supply network. If the hood was corectly
disconnected from the power supply, please wait a few minutes, and after the cooling the
lightbulb, it can be replaced.
CAUTION!
Do not touch light bulba as long as they are hot. Be careful not to touch directly the halogen
bulb with bare hands.
Turbine operation control:
• 0 - turns off the turbine
• 1 - turbine operation at minimum speed
• 2 - turbine operation at average speed
• 3 - turbine operation at maximum speed
Turbine is started by pressing the selected buton. Higher gear means grates air flow.
Lighting:

Carbon filter

Replacement of lightening

Mechanical control

17