How Do I Change The Protocol Mode; How Do I Set The Vlan Priority On The Iad; How Do I Set The Fax Function On The Iad - Huawei eSpace IAD Troubleshooting Manual

eSpace IAD
Troubleshooting
A: Log in to the CLI, and run the enable and configure terminal commands in sequence to
enter the global configuration mode. Then run the dev parameter set command in the
following modes:





4.2.7 How do I change the protocol mode

Q: How do I change the protocol mode?


4.2.8 How do I set the VLAN priority on the IAD

Q: How do I set the VLAN priority on the IAD?
A: You can set the VLAN priority in either of the following ways:



4.2.9 How do I set the fax function on the IAD

Q: How do I set the fax function on the IAD?
A: You can set the fax function in either of the following ways:
Issue 02 (2012-02-29)
IAD101H/102H
Run the devasi parameter set 1 command to set the upper limit, and run the devasi
parameter set 2 command to set the lower limit.
IAD104H
Run the devasi parameter set 3 command to set the upper limit, and run the devasi
parameter set 4 command to set the lower limit.
IAD1224
Run the devasi parameter set 1 command to set the upper limit, and run the devasi
parameter set 2 command to set the lower limit.
IAD208E(M), IAD132E(T)
Run the devasi parameter set 3 command to set the upper limit, and run the devasi
parameter set 4 command to set the lower limit.
A: You can do as follows:
− To change to the SIP mode, log in to the web management system, choose Advanced
Configuration > Protocol Mode, and select SIP; or log in to the CLI, run the enable
and configure terminal commands in sequence to enter the global configuration
mode, and run the protocol-mode sip command.
− To change to the MGCP mode, log in to the web management system, choose
Advanced Configuration > Protocol Mode, and select MGCP; or log in to the CLI,
run the enable and configure terminal commands in sequence to enter the global
configuration mode, and run the protocol-mode mgcp command.
IAD101H/102H/104H supports only the CLI mode.
Use the web management system. For details, see Configuration > Manual
Configuration (Web) > Advanced Configuration > Configuring the VLAN in the
eSpce IAD Product Documentation.
Use the CLI. For details, see Configuration > Manual Configuration (CLI) >
Advanced Configuration > Configuring the VLAN in the eSpce IAD Product
Documentation.
IAD101H/102H/104H supports only the CLI mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 FA Qs
103