ZyXEL Communications P-334WT Support Notes page 262

wan
show_runtime sa
spd
switch <on|off>
timer chk_my_ip
chk_conn.
<on|off>
<1~3600>
<0~255>
After a packet is IPSec processed and
will be sent to WAN side, this switch
is to control if this packet can be
applied IPSec again.
Remark: Command available since
3.50(WA.3)
display runtime phase 1 and phase 2
SA information
When a dynamic rule accepts a
request and a tunnel is established, a
runtime SPD is created according to
peer local IP address. This command
is to show these runtime SPD.
As long as there exists one active
IPSec rule, all packets will run into
IPSec process to check SPD. This
switch is to control if a packet should
do this. If it is turned on, even there
exists active IPSec rules, packets will
not run IPSec process.
- Adjust timer to check if WAN IP in
menu is changed
- Interval is in seconds
- Default is 10 seconds
- 0 is not a valid value
- Adjust auto-timer to check if any
IPsec connection has no traffic for
certain period. If yes, system will
disconnect it.
- Interval is in minutes
- Default is 2 minuets