ZyXEL Communications P-334WT Support Notes page 152

Using FTP to Upload the Firmware and Configuration Files
In addition to upload the firmware and configuration file via the console port and TFTP client, you can
also upload the firmware and configuration files to the Prestige using FTP.
To use this feature, your workstation must have a FTP client software. There are two examples as shown
below.
1. Using FTP command in terminal
2. Using FTP client software
1. Using FTP command in terminal
Use FTP client from your workstation to connect to the Prestige by entering the IP address of
Step 1
the Prestige.
Step 2 Press 'Enter' key to ignore the username, because the Prestige does not check the username.
Step 3 Enter the SMT password as the FTP login password, the default is '1234'.
Step 4 Enter command 'bin' to set the transfer type to binary.
Step 5 Use 'put' command to transfer the file to the Prestige.
Note: The remote file name for the firmware is 'ras' and for the configuration file is 'rom-0' (rom-zero,
not capital o).
Example:
C:\temp>ftp 202.132.155.97
Connected to 202.132.155.97.
220 FTP version 1.0 ready at Thu Jan 1 00:02:09 1970
User (202.132.155.97:(none)):
331 Enter PASS command
Password:****
230 Logged in
ftp> bin
200 Type I OK
ftp> put p312.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
<Enter>