ZyXEL Communications P-334WT Support Notes page 127

case, we intent to set to 'ffffffffffff' to mask the incoming source MAC address, [00 80 c8 4c ea
63].
Value (in hexadecimal)
Specify the MAC address
masked packet. If the result from the masked packet matches the 'Value', then the packet is
considered matched.
Action Matched=
Enter the action you want if the masked packet matches the 'Value'. In this case, we will drop it.
Action Not Matched=
Enter the action you want if the masked packet does not match the 'Value'. In this case, we will
forward it. If you want to configure more rules please select 'Check Next Rule' to start
configuring the next new rule. However, please note that the 'Filter Type' must be also 'Generic
Filter Rule' but not others. Because the Generic and TCPIP (IPX) filter rules must be in different
filter sets.
You can now apply it to the
Filter' can only be applied to the
configuring the TCPIP and IPX filters.
[00 80 c8 4c ea 63]
Menu 21.1.2 - Generic Filter Rule
Filter #: 1,2
Filter Type= Generic Filter Rule
Active= Yes
Offset= 6
Length= 6
Mask= ffffffffffff
Value= 0080c810234a
More= No
Action Matched= Drop
Action Not Matched= Forward
'General Ethernet Setup'
'Device Filter'
that the P-334WT should use to compare with the
Log= None
in Menu 3.1. Please note that the
but not the 'Protocol Filter'
'Generic
that is used for