Power Connector Cable - HP Spectre x360 Maintenance And Service Manual

Power connector cable

Table 5-22 Power connector cable spare part information
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Heat sink (see
c. Fan (see
d. System board (see
Remove the power connector cable:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the power connector cable to the top cover.
2. Remove the power connector cable (2).
Reverse this procedure to install the power connector cable.
Bottom cover on page
Battery on page 38)
Heat sink on page 50)
Fans on page 53)
System board on page
27), and then remove the following components:
54)
Component replacement procedures
Spare part number
L95627-001
61