System Board - HP Spectre x360 Maintenance And Service Manual

System board

NOTE: The system board spare part kit includes the processor, a graphics subsystem with discrete memory,
replacement thermal material, and the Windows 10 operating system.
Table 5-18 System board spare part information
Description
For use only on computer models equipped with a display assembly with OLED:
Equipped with an Intel Core i7-10750H processor, an NVIDIA GeForce GTX 1650Ti graphics subsystem with 4 GB of
discrete memory, and 16 GB of system memory
Equipped with an Intel Core i7-10510U processor, an NVIDIA GeForce MX330 graphics subsystem with 2 GB of
discrete memory, and 16 GB of system memory
For use only on computer models not equipped with a display assembly with OLED:
Equipped with an Intel Core i7-10750H processor, an NVIDIA GeForce GTX 1650Ti graphics subsystem with 4 GB of
discrete memory, and 16 GB of system memory
Equipped with an Intel Core i7-10750H processor, an NVIDIA GeForce GTX 1650Ti graphics subsystem with 4 GB of
discrete memory, and 8 GB of system memory
Equipped with an Intel Core i7-10510U processor, an NVIDIA GeForce MX330 graphics subsystem with 2 GB of
discrete memory, and 16 GB of system memory
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Heat sink (see
c. Fan (see
NOTE: When replacing the system board, make sure the following components are removed from
the defective system board and installed on the replacement system board:
Remove the system board:
1. Disconnect the rear speaker cables (1) from the system board.
2. Disconnect the webcam shutter cable (2) from the system board.
3. Disconnect the webcam/microphone module cable (3) from the system board.
4. Remove the shield (4) that secures the wireless antenna cables to the WLAN module terminals.
5. Disconnect the wireless antenna cables (5) from the WLAN module terminals.
NOTE:
black wireless antenna cable connects to the WLAN module #2/Aux terminal.
54 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page
Heat sink on page
Fans on page 53)
The #1/white wireless antenna cable connects to the WLAN module #1/Main terminal. The #2/
27), and then remove the following components:
38)
50)
Spare part number
L95651-601
L95652-601
L95649-601
L95648-601
L95650-601